Scope Base Torque Specs. SPUHR Scopemount 34mm Tube 30mm Height SP4601 It has always been my opinion that having a consistent torque on the action screws is more important than the number of foot lbs SCOPE RING RING SIZE / SCREWS TORQUE (In-Lb) VORTEX PRECISION RING: 30mm, 34mm, 1" 15-18: VORTEX RING BASE: Grade 8 Fasteners: 45 - 50: VORTEX PRO RING:
Monstrum Cantilever Scope Mount Torque Specs at Edwin Shroyer blog from xnwubenouiiqznb.s3.amazonaws.com
Assuming your firearm has the appropriate bases already properly installed, and your firearm is unloaded: Step 1 Torque settings are often specified by the manufacturer of the scope rings and mounts
Monstrum Cantilever Scope Mount Torque Specs at Edwin Shroyer blog
It is very unlikely that you will ever remove your scope base, but you might need to remove the scope from the rings if you desire a new scope or if you're scope was damaged and needs work Cal Zant is the shooter/author behind PrecisionRifleBlog.com Torque settings are often specified by the manufacturer of the scope rings and mounts
Monstrum Cantilever Scope Mount Torque Specs at Edwin Shroyer blog. maximum for steel receiver and around 15 inch-lbs for aluminum. More importantly, it prevent over-tightening which could strip the screws or damages the scope or rifle components, or under-tighten, which could cause […]
Scope ring/base torque spec Holy Cow! Page 2 Long Range Hunting Forum Expert Gear. Secure the scope rings to the base at the recommended torque value. The recommended torque values for tightening screws of individual assemblies for mounting optics given in in/lbs and Nm are: when mounting a Weaver/Picatinny rail on the action, 15-55 in/lbs or 1.69-6.21 Nm (Badger 15 in/lbs or 1.69 Nm), Warne and Nightforce 25 in/lbs or 2.82 Nm, Vortex 55 in/lbs or 6..